Distform MyChef 10 GN 1/1, Installation, Use And Maintenance Manual

Page: 49 / 63

170
When you have selected the program you want, start it with the button
for a few seconds. If the oven detects that the temperature within the chamber
is too high, it will automatically start the cooling process until the oven reaches
a temperature appropriate for the cleaning process. Once the temperature is
appropriate, the cleaning program will run.
The durations of the self-cleaning programs specified in Table 15 do not
take into account a potential cooling in the chamber.
Once the self-cleaning process has begun, do not, under any circumstances, open
the door. In case of an emergency, you may stop the cleaning process with the
button for a few seconds.
If the cleaning process has been stopped before automatically finishing,
you must repeat the cleaning process or run the rinsing program.
The oven will turn off automatically upon termination of the cleaning process.
Once you finish any of the cleaning programs, if you notice that detergent or
rinse aid remains in the chamber (including behind the fan guard), run the rinse
program or do a full rinse of the cooking chamber.
If there is a power outage during the cleaning process, an error message (Error
26) will appear on the control panel when the oven turns on again. If this occurs,
to remove any remnants of detergent or rinse aid in the chamber, run a rinsing
program.
Always run a self-cleaning or rinse program when Error 26 appears.
Clarification: You must load the product in the pump for the first use of
the self-cleaning system. Follow the instruction for clearing the pumps
described in section 9.2.2.2.