Dish Network DISH 311, User Manual

Page: 26 / 106

Page 21
Installing the Receiver in an Existing System
Page 21
8. If the
Point Dish
screen is not displayed on the TV, press
MENU-6-1-1
on the remote control.
9. Select
Check Switch
. When an attention screen displays, select
Test
.
10. The receiver begins performing the
Check Switch
tests. When it is
finished, the
Installation Summary
screen displays.
11. Make sure that the information on the
Installation Summary
screen
identifies your system correctly and shows all transponders for all sat-
ellites in your system.
12. Select
OK
to go to the
Point Dish
screen.
13. Select
Cancel
. An
Attention
screen will open asking the mounting and
positioning of your dish is complete with a
Locked
indication in the
Point Dish
screen. Select
Yes
.
14. After you select
Yes
, the receiver will begin taking a software
upgrade. You will see a
Warning
that vital program information will
now be downloaded into your receiver. You will also see a status bar
showing the progress of this upgrade.
15. Once the software upgrade is complete, you will see a message that
your receiver’s memory is being upgraded.
16. Do not disturb the receiver while the receiver’s memory is being
upgraded.
Note : If you are installing other DISH Pro receivers, be sure to run Check
Switch
on all of them, and allow them to take the necessary software
upgrade.
17. When the memory upgrade is complete, you will either be watching
TV or you will see a message asking you to activate your receiver.
18. If you are asked to activate your receiver, go to page 2 and follow the
instructions.