10
5.2 PTFE Membrane Vent
Membrane vents enable the free passage of gases and vapours and
equalize the pressure between the internal and ambient conditions. This
helps to protect and preserve the internal components of the battery.
5.3 Battery ON/OFF Key
Briefly
press the battery’s ON/OFF key to switch the battery ON.
Press and hold
the ON/OFF key while the battery is ON for longer than 5
seconds, and the key will arm the Remote Power-Off (RPO) Mode. When the
battery is in RPO mode, the battery will shut down once the ON/OFF key is
released.
5.4 At-a-glance LED
WARNING
ELECTRIC SHOCK AND FIRE HAZARD:
Always assumed the battery main relay to be
ON (Closed). Verify the terminal voltage with a voltmeter before battery handling and
installation. Even if the At-A-Glance LED shows that it may be OFF.
Failure to follow
these instructions may result in death or serious injury.
Solid Green LED:
The main relay is ON (Closed), the battery is ready for
operation.
Flashing Red LED:
The main relay is OFF (Open), the battery is in protection
mode, and a fault has occurred. For a list of faults, refer to
Table 2-4
. DLP-GC2
Protections Specifications
.
No LED:
The main relay is OFF (Open).
5.5 LYNK Port
LYNK Port allows multiple batteries in a string to communicate and interact
in a closed-loop network and to enable the battery string to be externally
monitored. LYNK Port also allows DLP batteries to be networked in a closed-
loop system with external power conversion and motor control devices which
can automate the system's configuration and optimize performance. Battery
datalogs can be downloaded with LYNK Gateway devices.
5.5.1 LYNK Port PIN Assignment
PIN Number
Function
1
ON/OFF Switch
2
LYNK Bus CAN L
3
LYNK Bus CAN H
4
LYNK Bus 12V +
5
LYNK Bus GND
Figure 3. 5 PIN M12
A-Code Circular
Metric Connectors.
