33
4 Filters
G
6.
Turn the central filter protective screen anti-clockwise
and pull it down from the central laminar filter (Fig. 21).
7.
For a rough clean, hold the central laminar filter over a
dustbin. Then knock it gently.
4.2
Replacing the
protective motor filter
1.
Switch the appliance off and observe the instructions
under
Z
Chapter 3.2, "Switching off and winding up the
power cable"
.
2.
Remove the dust container,
Z
Chapter 3.4, "Emptying
the dust container", Point 1
.
3.
Remove the protective motor filter (Fig. 23/1).
4.
Insert the new protective motor filter (Order Number,
Z
Chapter 9, "Spare parts"
).
5.
Place the dust container inside again. The container
clicks audibly into place.
4.3
Replacing the blow-out
filter
1.
Switch the appliance off and observe the instructions
under
Z
Chapter 3.2, "Switching off and winding up the
power cable"
.
2.
Remove the dust container,
Z
Chapter 3.4, "Emptying
the dust container", Point 1
.
3.
Remove the blow-out filter cover (Fig. 24/1) by turning it
10 degrees to the left and lifting it up.
4.
Remove the blow-out filter beneath this (Fig. 24/2).
5.
Insert the new filter (Order Number,
Z
Chapter 9,
"Spare parts"
).
6.
Then reinsert the blow-out filter cover again. Lock it by
turning it 10 degrees to the right.
7.
Place the dust container inside again. The container
clicks audibly into place.
NOTE:
If the central laminar filter is dirty, then rinse it thoroughly
with a shower head (Fig. 22). Do not use any brushes for
this.
Then leave the filter to dry (approx. 15 hours at room
temperature). Only use it again when it is completely dry.
Fig.21
Fig.22
Fig.23
1
Fig.24
1
2
02 Vision V1_de.book_gb.book Seite 33 Freitag, 4. Mai 2007 11:51 11
