9
Hold the dirt container lid
and grasp the filter tab.
Pull away from lid.
1.
TO REPLACE PLEATED FILTER
Return filter to dirt container
by placing on top of screen
inside dirt container.
IMPORTANT:
DO NOT
RETURN FILTER TO THE DIRT
CONTAINER BEFORE IT HAS
COMPLETELY DRIED.
1.
TO REPLACE FOAM FILTER
DIRT CONTAINER & FILTER REMOVAL & REPLACEMENT:
CONTINUED
*Regular Maintenance:
Each time the dirt container is emptied, the pleated filter should be cleaned. Tap the lid
firmly against the inside of a trash can until the dirt stops falling from the filter. (Filter will be discolored after use,
this will not affect the filter’s performance.) Do not brush the filter. The cleaning instructions may vary depending
on the dirt conditions. In some cases, more or less cleaning of the filter may be required.
It is recommended that
the filter be replaced once per year.
Return new filter to the dirt
container lid. Push filter into
place until it snaps to prevent
leakage.
Return dirt container to cleaner.
Align slot on bottom of dirt
container with tab on cleaner.
Push to snap into place.
2.
3.
Align tabs on lid with the
openings on the dirt container
and twist to close and secure
lid.
4.
BELT & BRUSHROLL: REMOVAL & REPLACEMENT
10
5
BELT STYLE
For Belt Style 5 replacement, please visit our website at www.dirtdevil.com to buy
online or call customer service at 1-800-321-1134.
TOOL REQUIRED: PHILLIPS OR FLATHEAD SCREWDRIVER
WARNING:
TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG CLEANER BEFORE CHANGING BELT
OR BRUSHROLL.
Lay cleaner flat and flip cleaner to expose
nozzle base. Base should lay flat and face
up. To remove nozzle guard, use Phillips
screwdriver to remove the three (3)
screws. Arrows show location of screws.
Lift and remove brushroll.
Dispose of old belt.
1.
3.
Rotate/pivot the nozzle guard
and pull off.
2.
TO REMOVE BELT
Slide belt onto motorshaft.
1.
Place new belt in area of
brushroll without bristles.
2.
TO REPLACE BELT OR BRUSHROLL
END CAP
MOTOR
SHAFT
With new belt in place,
pull and slide brushroll
into nozzle making sure
that the brushroll end
caps are in the correct
orientation (3a inset).
Rotate brushroll manually
to make sure belt is
properly aligned.
3.
3a.
Secure by aligning
the four (4) tabs in
the base slots.
SLOTS
TABS
4.
