DIRT CONTAINER & FILTER: REMOVAL & REPLACEMENT
7
WARNING:
TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE REMOVING OR REPLACING
FILTER.
NOTE:
For best performance, replace filter yearly.
Please use reminder label located on filter cap to record replacement date.
F2
FILTER TYPE
For F2 filter replacement, please call 1-800-321-1134 or visit our website at
www.dirtdevil.com to locate a dealer nearest you.
UNLOCK
Depress button on top
of dirt container lid to
remove dirt container.
Remove lid by grasping
handle on dirt container lid
and turn counter clockwise.
2.
Hold the dirt container and grasp the top of the filter.
Twist the filter counter clockwise to unlock (Diagram
3a). Pull the filter up and out.
1.
3.
3a.
Return dirt container
to base of unit.
Line up arrow on dirt
container with lock/
unlock arrows on dirt
container lid for proper
alignment. Turn clock-
wise to lock lid in
place.
UNLOCK
LOCK
Clean filter and empty dirt
container completely. See
“Regular Maintenance”
note below for instructions
on cleaning the filter.
Return lid to dirt
container.
Return filter to dirt
container. Twist filter
clockwise to lock into
position.
5.
7.
4.
*REGULAR MAINTENANCE:
Each time the dirt container is emptied, the filter should be cleaned. Tap the filter firmly
against the inside of a trash can until the dirt stops falling from the filter. (Filter will be discolored after use, this will
not affect the filter’s performance.) Do not brush the filter. The cleaning instructions may vary depending on the dirt
conditions. In some cases, more or less cleaning of the filter may be required.
6.
8.
8
BELT OR BRUSHROLL: REMOVAL & REPLACEMENT
BELT STYLE
15
For Belt Style 15 replacements, please call 1-800-321-1134 or visit our website at
www.dirtdevil.com to locate a dealer nearest you.
TOOL REQUIRED: PHILLIPS SCREWDRIVER
WARNING:
TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE CHANGING BELT OR
BRUSHROLL.
Lift and remove brushroll. Dispose
of old belt.
Slide belt onto motor shaft.
Place new belt in area of
brushroll without bristles.
TO REMOVE BELT
Lay cleaner flat and flip cleaner to
expose nozzle base. Base should lay
flat and face up. To remove nozzle
guard, use Phillips screwdriver to
remove the six (6) screws. Arrows
show location of screws.
Slide belt off motor shaft.
Tilt rollers up and away from
the base of the cleaner as you
remove the nozzle guard
4.
5.
TO REPLACE BELT OR BRUSHROLL
6.
With new belt in place, pull and slide
brushroll into nozzle making sure that
the brushroll end caps are in the correct
orientation (7a inset). Rotate brushroll
manually to make sure belt is properly
aligned.
Be sure to replace all six (6)
screws.
Reattach nozzle guard by
carefully sliding back into
place. Interlock rollers and
nozzle guard by tilting rollers
down towards the base while
replacing the nozzle guard.
7.
8.
9.
2.
1.
3.
7a.
MOTOR
SHAFT