DirecTV HR, User Manual

Page: 94 / 132

94
DIRECTV
®
PLUS DVR
USER GUIDE
- Check that nothing is between the remote control and the remote sensor.
- Make sure the remote control is in DIRECTV mode. Slide the MODE switch on the remote to the DIRECTV position so the remote will
control the DIRECTV
®
Receiver.
- Check the batteries in the remote control. They may be weak, dead or installed incorrectly. Try replacing batteries.
- If you’re entering a channel number that is less than four digits long, the receiver might wait two seconds before tuning to the channel.
Press ENTER after entering a channel number to tune immediately.
- If you are trying to operate a device other than the DIRECTV DVR that you have programmed the remote to control, make sure you first
slide the MODE switch to the mode that is programmed for that device (AV1 or AV2). The indicator light for the component you’re trying
to control should light up when you press a valid key for that component. If it doesn’t, make sure the MODE switch is in the correct
position.
- Make sure the device you are trying to control has been programmed to your DIRECTV Remote Control. See Chapter 6, “System Setup,
Remote Control” for instructions on how to program your remote to control other devices.
- If the indicator lights on the remote control start flashing, the batteries in the remote control are running low and should be replaced
soon. You may also see an onscreen message that the batteries are low. Note that when you replace the batteries, you should not have
to reprogram your remote to control other devices unless the batteries have been completely dead for a month or more.
My remote control doesn’t work
Solution:
Possible Causes:
- Weak batteries are almost always the problem.
- Trying to operate equipment other than your DIRECTV Receiver?
- Remote sensor on the receiver could be blocked.
Frequently Asked Questions