Module Reset
Page 8
1
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module. Press and hold the programming
button, then connect the 14-pin harness to the module.
10-pin
D2D
st
1
12-pin
14-pin
nd
2
th
4
rd
3
Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some settings (such
as RFTD and D2D options) may have to be reconfigured. See the
Feature & Option List
section of this guide.
2
Solid
&
Release
3
Release the programming button. The LED turns ON solid red.
Hard Reset
2
&
&
1
Wait 3 seconds until the LED turns ON solid orange then release the
programming button. The LED turns ON solid red.
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module. Press and hold the programming
button, then connect the 14-pin harness to the module.
10-pin
D2D
st
1
12-pin
14-pin
nd
2
th
4
rd
3
A module reset will only erase programming performed in the previous steps. All settings (firmware) and settings flashed
to the module using the web config tool will not be affected.
Solid
Release
Solid
Solid
Flashes
&
Wait 3 seconds until the LED turns ON solid orange, and wait 10 more seconds
until the LED starts to flash orange and red.
Press
the PTS (Push-to-Start) button once to turn the Ignition
OFF
.
1X
ENGINE
START
STOP
PUSH
4
5
The LED turns ON solid orange for 3 seconds, then shuts OFF.
&
Solid x3 Secs
Off
You have successfully completed the module programming sequence.
Rev.: 20170407
Platform: DBALL2
Firmware: GM9 Range Extender Ready (RXT) Installation v.2.05+
© 2017 Directed. All rights reserved.
