15
933.TL2 4.12.193.2 2015 Toyota Sienna (Smart Key)
© 2021-02-19 Directed. All rights reserved.
Module programming
(For
security-only programming
, see next section.)
1
Please
ensure
that the vehicle is in a safe location, and cannot move forward during
programming. For vehicles equipped with a manual transmission,
make sure
the
gearshift lever is in the neutral position.
2
DS3+: Connect
the 12-pin main power harness to the DS3+ module
FIRST
.
Wait until the LED turns ON solid red before proceeding to the next step.
DS4+: Connect
the 12-pin main power harness to the DS4+ module
FIRST
.
The LED will turn ON solid Blue for 1 second to confirm Bluetooth communication.
Wait until the LED turns ON solid red before proceeding to the next step.
3
Connect
the remaining harnesses to the module.
Note:
To skip the transponder programming and use convenience features only,
press
the programming button 5 times. The LED will turn orange then proceed to step 4.
4
Press
the Push-to-Start (PTS) button twice to turn the ignition ON. The LED turns on solid
green for 3 seconds and then shuts OFF.
The LED flashes orange if an OEM remote starter has been detected. See the section
"OEM remote starter detection" for more information.
Note:
If the transponder programming was skipped, the LED turns ON solid orange for
3 seconds then shuts off when programming is done.
5
Press
the Push-to-Start (PTS) button once to turn the vehicle ignition OFF once the
module is successfully programmed.
6
Pair
remotes (if applicable). For information on how to pair a specific remote, please
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
7
DATA Tach: Firmware using DATA Tach, the tachometer is preprogrammed for the
vehicle and no further action is required. For instructions on how to adjust tach or use
Virtual tach, refer to "Initialize Virtual Tach" (not needed with hardwired or data tach
applications).
Hardwire Tach: Firmware using the Violet/White Hardwire Tach input will require
programming. For instructions on how to program or adjust tach or use Virtual tach,
refer to "Initialize Virtual Tach" (not needed with hardwired or data tach applications).
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.
