12
933.TL2 4.12.193.2 2015 Toyota Sienna (Smart Key)
© 2021-02-19 Directed. All rights reserved.
Configuring the system
DS3+
Flashing the module using your computer:
1.
Disconnect
the main module from any (+) 12V power source, then
connect
it to your computer using the
XKLoader2
.
2. Go to
www.directechs.com
using Internet Explorer; the configuration wizard will be displayed automatically. Follow the
instructions in the pop-up window that will be displayed when the module is detected.
DS4+
Once the module is installed in the vehicle,
follow
the wiring diagram(s) related to your installation.
Launch
the DirectLink
application on your mobile device, and select
Configure DS4/DS4+
.
Follow
the on-screen instructions to configure the system.
Note
: Your system can also be configured using XKLoader2 on www.directechs.com.
8556T Temperature Sensor
The 8556T Temperature Sensor is optional, but included with your DS3+/DS4+ module.
When used, the Temperature Sensor must be plugged into the 2-pin black connector of your module.
Note
: When the system is configured as a remote starter, the temperature is reported by the 8556T
Temperature Sensor. When security features are enabled, it is reported by the 8504D Combo Sensor.
8504D Combo Sensor
The 8504D Combo Sensor is optional, but included with the purchase of a DS4SU security package.
The Combo Sensor is preset for the majority of applications; however, it can be adjusted using the DirectLink
application, as well as a compatible LED or LCD remote. Please refer to the instructions included with the DS4SU
for more information on how to make adjustments.
Note
: When the system is configured as a remote starter, the temperature is reported by the 8556T Temperature
Sensor. When security features are enabled, it is reported by the 8504D Combo Sensor.
IMPORTANT:
The Combo Sensor must be paired to the device before it can be used.
Pairing
To enter pairing:
1
Open
the driver side door.
2
Turn
the vehicle ignition to the ON position.
OR
Press
the PTS button to turn the ignition ON.
* The number of times the PTS button is pressed depends on the vehicle.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
OR
3
Within 10 seconds,
press
and
release
once, and then
press
and
hold
the programming button on the Control Center (antenna) or the
LED/Valet Pod (standalone switch) until the LED starts flashing then
release
the button.
* Your antenna may differ from the model shown in the illustration.
Press &
Release
&
&
&
OR
* *
Note
: Connected devices become registered within 4 to 6 seconds.
