Method 2 -
Without
FT CAN &
with
HS CAN connections &
with
transponder immobilizer.
*There are four Module programming possibilities, please review all methods to determine which one corresponds to your specific
vehicle.
To connect the module:
1
Please
ensure
that the vehicle is in a safe location and cannot move forward during
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect
all the harnesses to the Directed Digital Solutions,
EXCEPT
the 12-pin main power
harness.
Connect all but the
12-pin harness
3
Connect
the 12-pin main power harness, and wait until the LED turns ON solid red.
Must be connected LAST
&
Solid
4
Insert
and
turn
the key to the ON position. The LED starts flashing orange quickly.
Flashes
START
Key IN
ON
OFF
5
When the LED flashes red once, press on the programming button 5 times.
The LED will then flash orange slowly.
Note:
Depending on your vehicle, it may take up to 4 minutes to complete programming.
Flashes
Slowly
Flashes
x1
Press &
Release x5
6
The LED turns ON solid orange for 3 seconds, then shuts OFF.
Off
Solid
x3 Secs
7
Turn
vehicle ignition OFF once the module is successfully programmed.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
8
Pair
remotes (if applicable). For information on how to pair a specific remote, please
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
Pair
remotes*
9
DATA Tach: Firmware using DATA Tach, the tachometer is preprogrammed for the vehicle
and no further action is required. For instructions on how to adjust the tach or use Virtual
tach, refer to page 48.
Hardwire Tach: Firmware using the Violet/White Hardwired Tach input will require
programming. For instructions on how to program or adjust the tach or use Virtual tach, refer
to page 48.
Initialize
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.
42
Directed Digital Solutions HKHT1
© 2020-03-03 Directed. All rights reserved.
