73
4-Camera H.264 Security System Setup Guide
SECTION 8: DVR SYSTEM MENUS REFERENCE
BUZZER
: Set to ON for the buzzer to sound when an alarm is triggered by a sensor.
Prerecord
: Set to ON for the channel to record the 5 seconds of video occurring before the alarm is triggered by a sensor.
: Set to ON for a snapshot of the channel video to be send by email after a alarm was triggered by a sensor.
NOTE
If the output time, record, buzzer, prerecord and Email is OFF, the relevant option will not be triggered.
8.6.7 Motion Detection
Click
Tool Bar -> System settings
->
Alarm
->
Motion
to open the motion detection menu. In this menu, you can set the
Sensitivity, MD Detection area, Output, Record, Buzzer, Prerecord, and Email parameters.
CHANNEL
: Select the channel you need to setup. Open the drop-down menu to select the channel number
SWITCH
: Set the switch to ON to enable motion detection for the channel selected.
SENSITIVITY
: Set the sensitivity for the channel selected. A sensitivity of “1” indicates highest sensitivity. Open the drop-down list
to select a level appropriate for the channel.
MD AREA
: To improve DVR performance, use the MD Area feature to select only the areas of a channel video image to sense for
motion. For example, the image of a road near a walkway can be configured to sense for motion only in the walkway only.
To establish motion detection areas in the video image, click the
>>
icon on the
MD AREA
line. An image of the channel video will
appear, covered by a semi-transparent layer on a 10 x 15 block grid. Motion sensing for blocks in the grid can be toggled on and off
by clicking on the block area. Areas on the screen selected for motion sensing are indicated by removal of the semi-transparent layer
inside the block area.