8
INSTALLING THE MAIN GEAR WIRES.
Be careful do not to drill through the top of
the wing !
Landing gear wire.
3) The landing gear wire is held in place us-
ing two nylon landing gear straps and four
3mm x 15mm wood screws.
The straps should be located equal dis-
tance from the inside and outside ends of the
wire.
4) Using the two landing gear straps as a
guide, mark the locations of the four 3x
10mm mounting screws onto the wing sur-
face.
Pen.
Mark point.
Collar.
Repeat the procedure for the other aileron
servos.
1) Using a modeling knife, remove the cov-
ering from over the two main gear mounting
slots located in the bottom of the wing.
2) Insert the 90º bend of one main gear wire
into the predrilled hole in one mounting
slot.
Gear mouting slot.
5) Remove the two straps and the gear wire.
Drill four 1.5mm pilot holes into the wing
for the wood screws.
1.5mm
