Dinolift DINO 105TL, Operating Instructions Manual

Page: 26 / 82

DINO 105TL
26
11.1 DRIVING FROM THE LCB CENTRE (CHASSIS CONTROL CENTRE)
10. Turn the selector switch (Q1) to position "LCB control centre"
- After having levelled the chassis, and brought the outriggers into the support position,
you can operate the boom from the control levers S16, S17, S18 and the work platform
from the lever S20. To operate the boom movements, you need the keep either the
button S2 or S3 simultaneously depressed (selection of speed low/high).
Test the operation of the emergency descent system as follows:
1. Lift first the boom about 1–2 metres (lever S17) and then extend the telescope 1–2
metres (lever 8) keeping the emergency stop button depressed. The movement should now
stop.
2. To retract the telescope, turn the selector lever to the left and pump with the hand pump
until the telescope is fully retracted. The extension arm for the hand pump is under the
bottom plate of the turning device (see picture below).
3. To lower the boom, turn the selector lever to the right and pump with the hand pump until
the boom lowers onto the ground.
4. Pull up the emergency stop button.
DO NOT DAMAGE THE TOW-BAR JOCKEY WHEEL
Lock the selector switch (1) in position 1a before working under the boom.
Make sure that neither people nor load are on the platform.
Extension arm for
the hand pump
Selector
lever
Hand pump
Telescope in
Boom down
Crank for
emergency
swing