Operator’s Manual
Operating Instructions
GTWY1200 SERIES 15
Do Not Operate Unless:
You learn and practice the principles of safe
machine operation contained in this operator’s
manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation inspection.
3 Always perform function tests prior to use.
4 Inspect the workplace.
5 Only use the machine as it was intended.
Fundamentals
The Operating Instructions section provides
instructions for each aspect of machine
operation. It is the operator's responsibility to
follow all the safety rules and instructions in
the operator's, safety and responsibilities
manuals.
Using the machine for anything other than
lifting personnel, along with their tools and
materials, to an aerial work site is unsafe and
dangerous.
If more than one operator is expected to use a
machine at different times in the same work
shift, each operator is expected to follow all
safety rules and instructions in the operator’s
manual. That means every new operator
should perform a pre-operation inspection,
function tests and a work place inspection
before using the machine.
Setup
1. Position the machine on a firm surface
below the desired work area directly.
2. Connect to the appropriate power source:
DC models: Connect the battery pack. AC
models: Connect to a grounded 15A AC
power supply. Use a 12 gauge / 3.3mm
2
3-wire grounded extension cord no longer
than 50 feet / 13 m. The power light is on.
3. Turn the circuit breaker on .
4. Insert the key and turn to ground control
or platform control as you want.
5. Twist
to
release
the red Emergency Stop
buttons both at the ground and the
platform controls.
6. Pull the outrigger lock pin upt ,Turn the
outriggers out and adjust to level the
machine and raise the base casters
slightly off the ground.
7. Be sure all four interlock display lights at
the ground controls are on and all four
outriggers are in firm contact with the
ground.
8. Use the bubble level
to make sure the
machine is level.
Note: If adjustment is
necessary, check the bubble level and
interlock display again to make sure the
machine is level and all four interlock display
lights are on.
