This product is fitted with a replaceable battery in the controls.
To replace the battery, follow the steps below, shown in Fig. 6:
1. Unhinge the heater from the wall using the clips shown in Fig. 2 and locate
the battery module
2. Slide the catch and pull module from the controls.
3. Remove the coin cell battery and replace.
4. Slide module back in place, ensuring clip is engaged.
Important
During the initial operation, some odour may be noticed due to the newness of materials used
in manufacture. This is normal and will disappear after a short period of use. It is however
advisable to keep the room well ventilated.
Cleaning
WARNING - ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE
CLEANING THE HEATER.
Before commencing cleaning, isolate the heater from the electrical supply and allow it to cool.
The outside can be cleaned by wiping it over with a soft damp cloth and then dried. Do not
use abrasive cleaning powders or furniture polish, as this can damage the surface finish. To
release the heater from the wall bracket for cleaning or redecoration, depress the latch on both
brackets (See Fig. 2) and hinge forward.
Battery replacement
IMPORTANT: Before replacing the battery ensure the heater is isolated from the electricity
supply. NOTE - Battery should be disposed of in an appropriate manner
Fig. 6
4
Battery positive side up
2
1
3
21
