6
Super 1050 Assembly
Your new Super 1050 has been as-
sembled at the factory. All of the ad-
justments necessary to reload have
already been made, in fact we’ve even
adjusted the dies to reload the caliber
you have chosen. However, before you
can reload you must do some minor
assembly.
Due to variations in components,
check all stations for proper settings be-
fore loading ammunition. It is absolutely
necessary that you read the following in-
structions.
If you get stuck on something that you
don’t understand, call (800) 223-4570 for
technical assistance.
Step 1: Mounting the Super 1050
Select a clear area on your reloading
bench. Be certain your bench is free from
vibration and is strong enough to support
your Super 1050’s mass and operating
force. If possible, attach your bench to
the wall using screws.
Remove the Super 1050 main frame
from the packaging and place it on your
selected area. The crank extension
(#11061) should be to your right. Bring
the machine to the forward edge of
your bench – be sure to allow clearance
for operation of the handle. Mark the
four mounting holes using the machine
as a template. Remove the machine and
drill four 1/4” holes through the bench.
Replace the machine and bolt securely.
Fig. 1
Install the handle (#17071) as indi-
cated in the parts schematic. Secure in
place with the handle set screw
(#13432).
Fig. 2
You will note that there
are three different positions for mounting
the operating handle. Choose the one
that feels best for you. The longer the
handle, the less force required but the
stroke is longer.
The toolhead (#20420) is held down
on the main frame for shipping by the
use of plastic ties. Remove the ties while
holding the handle
Fig 3
.
Slowly move the handle up. This will
move the toolhead approximately three
inches to its “up” position. Note: If the
handle is not moving freely, carefully in-
spect for shipping damage.
Install the six brass locator buttons
around the shellplate (#12600*).
Fig. 4
Step 2: Installing the Casefeed Assembly
Using the screw provided (#13377) in-
stall the bin bracket (#13238).
Fig. 5
Install the bullet bin bracket (#12144)
to the casefeed post (#20641) using the
screw (#13685) as shown in the
schematic on page 30.
Screw the casefeed post studs
(#13271) to the main frame (place
the washer provided on the bottom
post only), tighten securely with an
Allen wrench through the cross hole
provided.
The casefeed mounting post assem-
bly (#20641) is attached to the casefeed
post studs (#13271) by the use of two
post bolts (#13205). Attach the power
cable and clamp and support bin
bracket (#10991) as shown in the
schematic on page 30.
Fig. 6
The casefeed bowl assembly needs to
Fig. 1 - Be sure the machine is to the for-
ward edge of the table or bench when mark-
ing the four holes to be drilled.
Fig. 2 - Note that there are three different
positions for mounting the operating handle.
Fig. 3 - Be sure to hold the operating handle
in place while cutting the plastic ties.
Fig. 4 - Locator button being inserted into its
proper position.
Fig. 5 - See the schematic on page 30 for
more details.
Super 1050 2018 New Casefeeder.qxp_Layout 1 1/31/18 6:47 AM Page 6
