18
P PARAMETER SETTING
Enter the P Parameter settings by cycling through the General Project Settings to the
end (when display ceases flashing) and simultaneously holding button and
button for 3 seconds. If required to exit at any parameter, hold button for 2
seconds. Use the button and button to select the value and confirm selection
by pressing the button. The parameter will be saved and the meter will enter the
next P parameter settings.
P1 Motor Characteristic Parameter Setting
P1 Display
The P1 settings are a motor characteristic parameter where:
P1 = Motor Gear Reduction Ratio × Number of Rotor Magnets
Rounding to a full number is necessary. The P1 setting ranges between 1 and 255.
P2 Wheel Speed Pulse Signal Setting
The P2 parameter setting will display on the meter after the P1 parameter setting has
been selected and confirmed. The KT-LCD3 will display as follows:
P2 Display