33
Alarm
5.6
In these section, you can configure the Motion Detection, I/O Alarm & PTZ Linkage.
Motion
5.6.1
This menu allows you to configure motion parameters. The motion detection is pretty straight
forward, the DVR simply compares one frame to another. A sufficient amount of difference is
interpreted as motion. When the motion is detected, the system can be set to automatically initiate
recording. In this menu you can select the channels where you want the motion detection
recording to take place.
If you set the motion detection at a high sensitivity level (“8” is the most sensitive) then the
frequency of false alarm events increases. If the sensitivity level is too low (“1” is the least
sensitive), you might increase the risk that a significant motion event will not trigger the motion
detection to record.
Channel:
Select the channel you want to set the motion detection.
Enable:
Enable or disable the function.
Buzzer:
The DVR can use its internal buzzer to emit an alarm tone. You can set the buzzer
duration in seconds when the motion is detected.
Sensitivity:
Set the sensitivity level.
Area:
To setup motion area, click
Setup.
