© 2022 Digitrax, Inc.
www.digitrax.com
15
15
5.2 Functions 10 through 28 (F10 - F28):
From the Home Operations Screen, press the
labeled “Fn+00” to cycle
through the functions “Fn+10” and “Fn+20”. When “Fn+10” is displayed over
the soft key the numeric keypad will control functions 10-19. If “Fn+20” is dis-
played the keypad will control functions 20-28. Press the
again to return to
“Fn+00” which will allow the keypad to control functions 0-9. In addition to
watching the soft key data the full function number and status will be displayed
in the
Function Bar
area of the display.
5.3 Fn Info+ : expanded function status:
If you wish to view the status of all 29 functions at once you can use the “Fn
Info+” soft key. From the Home Operations Screen, press the
labeled “Fn
Info+” this will expand the
Function Bar
area to show functions 0-28. To col-
lapse this function display press the
then labeled “Fn Info-”.
NOTE
: The functions controlled by keypad still correspond to the indicated
status of the
key; “Fn+00”, “Fn+10”, or “Fn+20”.
5.4 Troubleshooting Function Operation:
If the function you want to operate does not respond, check the following:
1. Is Track Status on or lit? If not, press the
key to turn it on.
2. Did you select the correct loco? If not, select it now.
3. Is the function you want to use installed in the loco? If not, you may need to
install it. Most new locos have a head lamp/backup lamp installed, but most
do not have any additional lights or sounds installed.
4. Change the position of the
Direction Control switch
and see if the lamp
comes on in the other direction. If the normal direction of travel feature in
the decoder loco is set for the opposite of what you were expecting, you
will see the head lamp operating in what you expected to be the reverse
direction and vice versa for the back up lamp. See your Decoder Manual for
information about how to change the Normal Direction of Travel (NDOT).
