DigiTech JamMan SOLO XT, Owner'S Manual

Page: 43 / 72

37
Recording Loops Sequentially Using JamSync
To record loops to a master and slave sequentially using JamSync:
1.
Select an empty memory location in
each JamMan Solo XT device using
the
<UP/DOWN>
buttons (
LOOP
and
SINGLE
LEDs will be off).
2.
If you wish to play to the Rhythm
Guide Track (optional), tap the master
device’s
<TEMPO>
button a few
times at the rate you want the phrase
tempo to be. You will begin to hear
the Rhythm Guide Track and the
beats will be indicated by a flashing
TEMPO
button LED. When using the
Rhythm Guide Track, time signature
can be manually set to another time
signature other than the default 4
beats per measure (see “
Setup > Time
Signature
”).
3.
Press the
<PEDAL SWITCH>
on the
slave device. This will arm the slave
for recording, indicated by a flashing
red
STATUS
LED.
4.
Press the
<PEDAL SWITCH>
on the
master device to initiate recording
and begin playing. If you set a tempo
in step 2, you will receive a one
measure count in, indicated by a
flashing red and green
STATUS
LED.
After the count in, begin playing with
the first beat to start recording.
Recording will be indicated by a solid
red
STATUS
LED.
5.
As soon as you’re done recording,
press the
<PEDAL SWITCH>
again to stop recording and initiate
playback. At the same time, the slave
device will begin recording, indicated
by a solid red
STATUS
LED. Play the
phrase you would like recorded in
the slave device.