DigiTech JamMan SOLO XT, Owner'S Manual

Page: 35 / 72

29
Erasing All Loops (Internal Memory)
The JamMan Solo XT allows you to quickly erase all loops from internal memory.
WarNINg!
Erasure of all loops cannot be undone! You should backup any loops you wish to keep,
using the JamManager XT loop librarian management software, before erasing all loops.
To erase all loops from internal memory:
1.
Ensure an internal memory location
has been selected (the
CARD MEM
LED should be off). If the
CARD MEM
LED is on, press and hold the
<UP>
or
DOWN>
button until the LED
goes out.
2.
Press and hold the
<STORE>
button
for approximately four seconds until
the display shows
Eri
(Erase Internal)
then release. The
STORE
button LED
will begin flashing, waiting for erase
confirmation.
3.
Press the
<STORE>
button again. The
display will read
E
?
(Erase Loops?).
4.
To continue with the erasure of all
loops from internal memory, press
and hold the
<STORE>
button until
the display reads
buS
then release.
Wait for the JamMan Solo XT to
finish erasing all loops from internal
memory. To abort procedure, press
the
<PEDAL SWITCH>
.