D-FORCE1400VA SLIDING GATE OPERATOR
pressed the LED will light.
f)
LED 5 indicate the ‘O/S/C’ external button, if the button is
pressed the LED will light.
g)
LED 6 indicate the ‘pedestrian switch’ external button, if the
button is pressed the LED will light.
h)
LED 7 indicate the ‘infrared sensor’ status, if the output is
connected the LED will light.
i)
LED 9 indicate the ‘Loop detector’ status, if the output is
connected the LED will light.
j)
LED 10 indicate the ‘Close limit switch’ status, if the switch is
connected the LED will light.
k)
LED 12 indicate the ‘Open limit switch’ status, if the switch is
connected the LED will light.
All these LED position see the Fig.8
10.
Maintenance
Check the door once a month. The door should be carefully checked
for balance. The door must be in good working order.
We suggest for safety reasons, photocells be used on all gates.
Disconnect from mains supply before replacing bulb.
Be sure to read the entire manual before attempting to perform any
installation or service to the door operator.
Our company reserves the right to change the design and specification
without prior notification.
11.
Troubleshooting
Trouble
Possible causes
Solutions
21
