4
SYSTEM & INSTALLATION
System Includes
•
LCD monitor
•
Cable for VGA connection
•
Cable for Touch screen connection ( option if touch screen is fitted )
•
Power supply: 100 – 240V AC input, 12V DC output
Please check that each of the above are included.
When unpacking and during use care must be taken not to
press the surface of the display, the LCD is fragile.
Hardware Requirements
•
IBM AT 286/386/486/Pentium compatible computer with standard graphics
card with 15 pin analog VGA output.
Installation & Setup
If you have a DV-3000 model with a touch screen installed, also refer to the
section on Touch Screen monitor setup.
•
Prepare the computer for connection by setting the monitor resolution to
match the resolution of the DV-3000 or lower and the vertical refresh rate to
60Hz.
•
Power off the computer.
•
Connect the monitor and the computer using the VGA cable provided.
•
Connect the monitor to the power supply.
•
If you have a DV-3000 model with a touch screen installed it would be at this
stage that you connect the cable from the monitor’s AUX input port to the
computer’s COM1 or COM2 port using a standard serial cable. See the
following section on Touch Screen monitor setup.
•
Turn on the computer then the monitor.
