Digital Projection
HIGHlite Laser II 3D Series
Rev C April 2017
Page 19
Important Information
Changing the filters
Before changing the filters, always make sure the projector is switched off and fully
disconnected from its power supply.
When changing the filters, avoid using excessive force as this may damage the
equipment.
1. Remove the
two screws
1
holding the filter cover.
2. Remove the
filter cover
2
.
3. Remove the old
filter
3
.
4. Place the new filter in the slot. Make sure the
air flow arrow
4
points toward the projector, as
shown in the illustration.
5. Replace the filter cover and tighten the screws.
2
1
3
4
