on the remote control until the function required is shown.
Page 3.4
Rev A October 2010
3. Getting Started
Digital Projection
HIGHlite 6000
User Manual
Brightness
Contrast
·
Notes
Always allow the lamp to cool
for 5 minutes before:
- disconnecting the power
moving the projector
- changing the lamp
Switching the projector off
Press POWER OFF
on the remote control or POWER
on the
projector control panel, then press the button a second time to confirm your
intention to switch off.
The lamp will switch off, and the power indicator on the control panel will flash
blue for approximately 30 seconds until the lamp has cooled down.
Wait until the power indicator has switched off and the standby indicator on the
projector control panel shows amber. The projector will now be in STANDBY
mode.
Disconnect the power cable from the projector.
·
·
·
LENS
Adjusting the projected image
Lens Shift
Press
Each press of the lens button will cycle through the lens functions in the following
order:
1. FOCUS
2. ZOOM
3. SHIFT
A test pattern with a function indicator will be shown with each press of the lens
button. The pattern will time out after 15s of no button presses, or can be removed
by pressing the menu or OK button.
Image Quality
No image quality adjustments can be made from the remote control. Please refer to
the
Userware Section 5
