Page 3.2
Rev A October 2010
3. Getting Started
Digital Projection
HIGHlite 6000
User Manual
Switching the projector on
Connect the power cable between the mains supply and the projector.
Wait until the selftest has completed and the standby indicator on the projector
control panel shows amber. The lamp will be off and the projector will be in
STANDBY mode.
Press POWER ON
on the remote control or POWER
on the projector
control panel to switch the projector ON. The power indicator on the control
panel will flash blue for approximately 30 seconds, whilst the lamp comes up to
full brightness. When the projector is ready for use, the power indicator will show
a steady blue.
·
·
Notes
For more information about
positioning the screen and
projector, see
Positioning
the screen and projector
, in
section 2. of the User Manual:
Installation
.
For more detailed information
about:
using the control keys on the
remote control or the projector
control panel,
see
section 5. of the User
Manual: Controlling the
projector
.
If the red
ISSUE
indicator is
illuminated continuously or
flashing, see
Error Codes
in
section 7 of the User Manual:
Appendix
, for more information
Do not mix an old battery with
a new one or different types of
batteries.
If you will not use the remote
control for a long time, remove
the batteries to avoid damage
from battery leakage.
Inserting batteries into the remote control
Open the battery compartment and insert two AA size batteries
(supplied), making sure they are inserted the correct way round, as shown
below.
·
Positioning the screen and projector
Install the screen, ensuring that it is in the best position for viewing by your
audience.
Mount the projector, ensuring that it is at a suitable distance from the screen for
the image to fill the screen, and that it is perpendicular to the sceen.
·
·
Power
connection
Projector
control panel
