page 48
Digital Projection E-Vision 6800 3D Series
Operating Guide
MENU MAP
Rev A January 2015
SETUP
Orientation: Desktop Front, Ceiling Front, Desktop Rear, Ceiling Rear
Network
IP Address: numeric input (default IP address is 192.168.0.100)
Subnet Mask, Gateway, DNS: numeric input
DHCP: On, Off
Apply (command)
Standby Power: On, Off
Information only: MAC Address
RS232
Baud Rate: 38400, 19200, 9600
Channel: Local, HDBaseT
Security
Control Panel Lock: On, Off
Security Lock: On, Off
Filter
Filter Message: Off, 100 hours, 200 hours, 500 hours, 1000 hours
Filter Reset (command)
System
Auto Source: On, Off
Auto Power Off: On, Off
Auto Power On: On, Off
Startup Logo: On, Off
Blank Screen: Logo, Blue, Black
Trigger: On, Off
Infrared Sensor: Both, Front, Rear
Resync Adjust: Always, Auto
Language: English, Français, Español, Deutsch, Português,
简体中文, 繁體中文, 日本語
, 한국어
Factory Reset (command)
INFORMATION
Model, Serial Number, Software Version 1, Software Version 2, Filter Time, Power On Time
Source Information:
Active Source, Pixel Clock, Signal Format, H/V Refresh Rate, Sync Type, Sync Polarity, Scan
Type, Video Type
Menu
Submenus and controls
Notes
Some of the information in this menu
map is summarised. See the actual
menu on the projector for full detail.
Some menu options and controls
may not be available due to settings
in other menus. These will be
shaded grey on the actual menu.
Where it would be helpful, some
menu options are described in more
detail earlier in this operating guide.
Some settings are associated with
the current input and the value of
the
Image Mode
setting (
Bright
,
Presentation
or
Video
). The
projector automatically stores values
of such settings to reuse when an
Input
/
Image Mode
combination
is selected again. For example, if
you increase the
Contrast
value
while on the DVI-D input with I
mage
Mode
set to
Bright
, the next time
you use the DVI-D input with
Image
Mode
set to
Bright
, the projector
will automatically set the same
Contrast
value.
Settings NOT associated with an
Input
/
Image Mode
combination
are called
global settings
and are
indicated with a globe icon
in
this section.
