page 51
Digital Projection E-Vision 6800 3D Series
Remote Communications Guide
INTRODUCTION
Rev A January 2015
Introduction
The projector can be controlled by using an external control system or a PC via an RS232 or LAN interface, using a terminal-emulation
program.
Network setup
1. Connect the projector to a LAN network.
2. Open the
Setup > Network
menu and edit network settings. The default IP address is
192.168.0.100
and the TCP port number is
7000
.
Serial Port setup
•
Baud rate: 9,600 bps (default), 19,200 bps or 38,400 bps.
•
Data length: 8 bits
•
Stop bits: one
•
Parity: none
•
Flow control: none
Notes
Details of how to connect to
the projector using the LAN or
RS232 input, can be found in the
Connections Guide
.
Furhter details about setting up
a LAN or Serial connection and
changing network settings can be
found in the
Operating Guide
.
Only one control path at a time
should be used for protocol control.
Attempts to send commands to both
serial and network ports at the same
time may result in unpredicatable
behaviour.
The baud rate can be adjusted. For
details, see the
Operating Guide
.
