Removing Fixed Disk Drives
Remove RZ2x
Disk Drives
Remove all the supported RZ2
x
disk drives from the drive plate.
Two of these drives can be installed into the VAXstation 4000
system unit.
To remove an RZ2
x
disk drive from the model 30 or 38, do the
following and refer to Figure 2–2:
1. Disconnect the SCSI and power cable from the disk drive.
2. Push down the drive plate lever and slide the RZ2
x
disk
drive over the lever until the fixed disk drive comes up and
out of the keyholes on the plate.
3. Remove the mounting plate from the drive. The RZ2
x
drives have a different mounting plate when installed in the
VAXstation 4000 system unit.
Model 30 Only:
Remove the drive plate first to access the screws that
hold the drive to the drive plate. (See Figure 2–5.)
Removing Options from a Model 30 and 38 Workstation 2–3