Digital Equipment Pro-face PS-3450A Series, Reference Manual, Page: 87 / 103

PS-345XA Reference Manual
4-2
4.1 Problems and Countermeasures
Problem Countermeasure and reference page
Nothing appears on the screen. Is the power cable connected properly?
Is the power supply/voltage within the range of the
specifications?
Is the backlight lit? If the backlight is burnt out, replace it.
Does the status LED illuminate in green?
The OS does not operate
properly. Is [Type] in [Primary Slave] set to [Auto] in the IDE
setting?
Did you connect a new hard disk drive or commercial
USB memory which does not require boot-up?
The connected peripheral device
does not work. Is the power cable connected properly?
Is the peripheral device connected properly?
-> Refer to the manual for the connected device.
Does the device require driver setup?
-> Refer to the manual for the connected device and set
the driver properly.
Was the PS-A started with a USB device connected?
-> If a USB device such as USB memory is connected to
the PS-A when the PS-A is started, the following
phenomenon may occur, depending on the device:
• It takes about 1 minute before the OS starts up.
• The PS-A does not recognize the USB device.
These problems may be solved by setting [Power on
Delay] to [Enable].
SEE
PS-3450A/3451A Hardware Manual
3 Hardware Installation
SEE
PS-3450A/3451A Hardware Manual
2 Specifications
SEE
PS-3450A/3451A Hardware Manual
4 Maintenance
SEE
If the status LED does not illuminate, contact your
local PS-A distributor.
SEE
„
Primary Master / Primary Slave / Secondary
Master (page2-5)
SEE
2.2.5 Boot (page2-28)
SEE
PS-3450A/3451A Hardware Manual
3 Hardware Installation