Utilities & Configuration
Digital PRIORIS ZX Server
20
MCS Logistics Engineering - Nijmegen
BIOS SETUP OPTIONS (Exit Section)
BIOS Setup Field
Settings
Comments
Exit Saving
Changes
Press Enter
Same as hitting [F10] key
Exit Discarding
Changes
Press Enter
All that work for nothing. No changes will be saved to
the CMOS/NVRAM areas.
Load Setup Defaults
Press Enter
Same as hitting [F5] key.
Discard Changes
Press Enter
Gives user another chance to make the required changes
with re-booting the system.
Default Values listed in
Boldface
SCSI
Select
Utility
The Prioris server comes with an Adaptec controller and a SCSI
Select
configuration utility. This utility
enables to change host controller settings without opening the server or handling the SCSI controller board.
Use SCSI
Select
to:
♦
Check factory default settings for each device on the SCSI bus.
♦
Change SCSI device settings that might conflict with other SCSI devices.
♦
Perform low-level formatting on new SCSI disk drives.
To start the SCSI
Select
configuration utility:
1) Press
Ctrl + A
when the BIOS banner appears during the boot process.
2) When the SCSI
Select
configuration utility appears, follow the instructions on the screen to configure
the SCSI controller and run SCSI disk drive utilities.
RAID Configuration Utility
RAID-ready Prioris ZX 5000 MP servers include a Mylex RAID controller and RAID configuration utility.
If the RAID controller was factory installed, the RAID configuration utility appears when the server is
booted with the ServerWORKS Quick Launch CD-ROM disk. Use this utility to configure the RAID
array.
Refer to the Mylex User’s Manuals for more information.
