
6
DECrepeater 900GM Installation and Configuration
Installing the Module (Cont.)
3
Verify that the module’s Power
LED lights immediately, and that the
Module OK
LED lights within 1
minute.
a. The Power LED lights when
power is applied, then the mod-
ule performs a self-test.
b. After the module completes
self-test, the Module OK
LED lights and remains lit, then
the Hub Manager status display
shows:
DECrepeater 900GM
up
NOTE:
If the LEDs do not operate as described, refer to the
section titled Problem Solving Using the LEDs.
4
Connect the port cables.
Connect the two Telco cables and the AUI cable, then go to the section titled
Configuring the Module. See your network manager if you are not sure which
cables to connect.
NOTE:
All cables should be installed, tested, and tagged at the
site, prior to this installation.
•
To connect the Telco cables, go to step 5.
•
To connect the AUI cable, go to step 6.
LKG–8760-93I