Digital Equipment DECconcentrator 500, Installation Manual, Page: 69 / 98

4–24 DECconcentrator 500 Installation
4.8 Selecting the Add Trap Address Option
Select option 5 of the Main Menu to add a trap address. Enter the trap address at the
prompt and press
RET
. The trap address you entered appears at the bottom of the
screen.
4.9 Selecting the Remove Trap Address Option
Select option 6 of the Main Menu to remove a trap address. Enter the trap address at
the prompt and press
RET
. The trap address you removed appears at the bottom of
the screen.
4.10 Selecting the Reset Option
Selecting option 7 of the Main Menu resets the concentrator and zeros all counters. If
the reset to defaults switch on the Network Management Card is on, the system pa-
rameters will reset to the default settings. If the resets to defaults switch on the Net-
work Management Card is off, the system parameters will remain the same.
NOTE
The Show Device Characteristics option displays the
position of the Network Management Card reset to de-
faults switch.
“RESET box, continue?” appears at the bottom of the screen. Press Y for yes or
N
for no.
If you pressed Y , “Resetting; please wait” appears at the bottom of the screen.
Reset is complete when the screen clears and the main menu reappears.
NOTE
If your terminal is set for 19200 baud rate, resetting will
default to 2400 baud rate. After reset is complete, you
must change the setup on your terminal to 2400. Change
the baud rate back to 19200 by following the procedures
in Section 4.2.