Digital Electronics Corporation Pro-face PS-2000B-41, User Manual, Page: 57 / 105

Chapter 3 - System Setup
PS-2000B Series User Manual 3-14
„ „
„ „ „
Suspend Type
Designates the type of suspend method used. The available settings are [Stop
Grant] and [PWRON Suspend]. The factory default setting is [Stop Grant].
„ „ „ „ „
Suspend Mode
When enabled, designates the period of time before all devices except the CPU
are shut down. The available settings are [1Min], [2Min], [4Min], [8Min],
[12Min], [20Min], [30Min], [40Min], [1Hour] and [Disabled]. The factory
default setting is [Disabled].
„
HDD Power Down
After the hard disk's motor stops, this setting designates the length of time until
the PS-B unit enters energy-saving mode. The available selections are[1Min],
[2Min], [3Min], [4Min], [5Min], [6Min], [7Min], [8Min], [9Min], [10Min],
[11Min], [12Min], [13Min], [14Min], [15Min] or [Disabled]. [Disabled] is
factory set and recommended for most users.
„
Wake-Up by PCI Card
Enables/disables waking up the PS-B's system via an expansion board signal.
The two selections available are [Disabled] and [Enabled]. The [Disabled]
selection is factory set and recommended for most users.
„ „ „ „ „
**Reload Global Timer Events**
This feature sets the event that reloads the amount (period) of PS-B unit idle
time prior to changing to energy-saving mode. Thus, when an event occurs for
any of the items in this area that are set to [Enabled], the PS-B unit will recover
from energy-saving mode.Enabled/disabled is possble for the following set-
tings: Primary IDE 0, Primary IDE 1, Secondary IDE 0, Secondary IDE 1,
FDD, COM, LPT Port, PCI PIRQ[A-D]#. Factory settings are [Disabled] and
recommended for most users.