TURNING ON THE PRINT STATION FOR THE FIRST TIME
To turn the print station on insert the power jack
into the DC power connector.
There is no on/off switch.
The first time the print station is turned on, as
received from the factory, the LCD will look like
the illustration on the left. Each line gives
important information regarding the system:
EVSC STOPPED
HD1- - >SPEED=120
EVOLUTION SC
The Top line indicates the
PRINT SYSTEM TYPE
and the operating mode of the
unit: “STOPPED” when in Command mode, “ PRINTING” when in Print mode,
and “MESSAGE ENTRY when in message entry.
The 2
nd
line shows the print head currently selected, the direction of travel for the
product and the programmed SPEED.
The lower half two lines of the display shows the message entered for printing.
This may represent one or two lines of code.
CHECKING SYSTEM INFORMATION
Verify system information by pressing the V key
on the hand held controller keyboard. The LCD
screen will display the software, firmware, serial
number and options enabled. Enabled options
are indicated on the second line as a series of +
characters where the first + indicates option
pack 1, the indicates option pack 1.5 and the last + indicates option
pack 2.
CONTROLLER 1.06
EVSC 1.03_++++
PRINTER SN284955
ANY KEY TO EXIT
CHECKING LOADED FONTS
Press the FONT
key in the COMMAND
mode to check what fonts are currently loaded
in the print head.
NOTE: The Evolution small character has 5
font styles:
12x9
1
line
of
text
EVSC ACTIVE FONTS
2 LINE DDI S_5
1 LINE DDI S_7
1 LINE DDI B_7
1 LINE DDI S_12
1 LINE DDI B_12
ANY KEY TO EXIT
12x9 bold
1 line of text
7x5
1
line
of
text
7x5 bold
1 line of text
5x5
2
lines
of
text
3
EVOLUTION SC
SYSTEM MANUAL Issue 1.1 15 November 2006
