Page 20
Please read the instructions carefully prior to installation
DGHDP1 -
DigiSender® HD Pro - 1080p Powerline AV Sender System
Advanced Procedures
Resetting the PLC Settings to Factory Defaults
The following procedure will revert the DigiSender® HD Pro PLC settings back to factory default and should only
be used during troubleshooting.
1.
Reset the Transmitter PLC Settings to Factory Defaults:
At the Transmitter, press the
Factory Button
on the DigiSender® remote control
CONTINUOUSLY
(in
rapid succession) until the
Power LED and the Sync LED goes OFF
, and then press the
OK Button
on the DigiSender® remote control.
The Power and Sync LEDs will flash
OFF-ON-OFF-ON
and then the Transmitter will reboot itself.
The Transmitter PLC settings have now been set back to the factory defaults.
2.
Reset the Receiver PLC Settings to Factory Defaults:
At the Receiver, press the
Factory Button
on the DigiSender® remote control, in rapid succession,
until the receiving TV displays the message “
Confirm - Reset PLC Settings to Factory Defaults?
”
and then press the
OK Button
on the DigiSender® remote control (you can press any other button on
the DigiSender® remote control to cancel the operation.
The Receiver PLC settings have now been set back to the factory defaults.
Note:
After completing the
Resetting the PLC Settings to Factory Defaults
procedure you will need to complete
the
PLC Grouping
procedure on page 18.