Page 19
Please read the instructions carefully prior to installation
DGHDP1 -
DigiSender® HD Pro - 1080p Powerline AV Sender System
Advanced Procedures
Resetting the System Settings to Factory Defaults
The following procedure will revert the DigiSender® HD Pro system settings back to factory default and should
only be used during troubleshooting.
1.
Reset the Transmitter System Settings to Factory Defaults:
At the Transmitter, press the
Group Button
on the DigiSender® remote control
CONTINUOUSLY
(in
rapid succession) until both the
Power LED goes OFF and the Sync LED comes ON
and then press
the
OK Button
on the DigiSender® remote control.
The Power and Sync LEDs will flash
OFF-ON-OFF-ON
and then the Transmitter will reboot itself.
The Transmitter system settings have now been set back to the factory defaults.
2.
Reset the Receiver System Settings to Factory Defaults:
At the Receiver, press the
Group Button
on the DigiSender® remote control
AT LEAST 5 TIMES
(in
rapid succession) until the receiving TV displays the message
“Confirm - Reset System Settings to
Factory Defaults?”
. Then press and hold the
Group Button
on the back of the Receiver for
approximately 6 seconds.
The receiving TV will display the message
“System Settings Reset to Factory Defaults”
and then
the screen will go blank and the TV will display the message
“Not Synced - Please perform Syncing
Operation”
.
The Receiver system settings have now been set back to the factory defaults.
Note:
After completing the
Resetting the System Settings to Factory Defaults
procedure you will need to com-
plete the
Transmitter & Receiver Syncing
procedure on page 17.