digiO2 ECG-10X, User Manual

Page: 5 / 13

<NOTE>
If the ECG is interfered by electrostatic discharge, the LCM may show "analysis failed" as follow:
Please wait 30 seconds and then measure again.
Important Notes on Taking Measurement
In order to obtain an accurate ECG/EKG reading, it is important that
measurement is taken correctly. Before taking measurement for the first
time, read these instructions carefully and make sure you observe the
following points each time you take measurement.
． Make sure that the electrodes are directly touching your skin.
． If your hand or skin is dry, wipe them with a damp towel so that
they are slightly moist.
．
If the electrodes are dirty, wipe any dirt off with a soft cloth or a cotton
swab moistened with disinfectant alcohol.
．
Do not use disinfectant alcohol to clean the unit except the electrodes.
． Do not move during measurement.
． Movement including talking, coughing, or sneezing during
measurement can affect the measurement results.
． If the position of your finger or arm is inappropriate during measurement,
the results may be inaccurate, so be sure to check their positions
before taking a measurement.
． After taking measurement, disinfect the electrodes by wiping them
with a soft cloth or cotton swab moistened with disinfectant alcohol. If
you do not disinfect the electrodes there is a risk of skin disease.
． Review Measurement Record
Historical record page will show
all record that is stored within the
device, press to select the
desired record for clearer
ECG/EKG data.
The ECG/EKG record will start
playing automatically, press
to slow down, press to pause
/resume and to exit.
Please note that if the record
hasn’t been uploaded, it will
confirm repeatedly.
Historical Record
Historical record page can be accessed directly after measurement or through
Menu selection.
06 07
Heart Rate
Scale Indicator
ECG/EKG
Waveform
Measurement
Time Indicator
=>