Installation
For illustration, a standard body, keypad lock with a bolt rear unit is used.
Insert the locking nuts on the screw posts and tighten
using the ratchet/screw gun.
u
Do not over tighten.
Hold the front unit against the front of the door. Use the
screws of the rear unit as a guide then slide the front
and rear units together.
Make sure the connector pins align properly with the
connector.
If properly connected, a triple beep will be heard and
the LED will flash three times.
If required, connect the pin extender to the rear unit.
Insert the front unit screw posts through the door
mounting holes.
11
1
3
2
5
4
