Installation
For illustration, a standard body, keypad lock with a bolt rear unit is used.
Place the plastic ring on the front unit.
If required, connect the pin extender to the rear unit.
Make sure the connector pins align properly with the
connector.
If properly connected, a triple beep will be heard and
the LED will flash three times.
Insert the locking nuts on the screw posts and tighten
using the ratchet/screw gun.
u
Do not over tighten.
Hold the front unit against the front of the door. Use
the rear unit mounting holes as a guide, then slide the
front and rear units together.
Insert the front unit screw posts through the door
mounting holes.
5
1
2
3
5
4
6