Installation
Place the plastic ring on the front unit.
Insert the front unit nut posts through the door mounting
holes.
Place the split lock washers on the phillips head screws
and insert them through the rear unit mounting holes.
Make sure the connector pins align properly with the
connector.
If properly connected, a triple beep will be heard and
the LED will flash three times.
Hold the front unit against the front of the door. Use
the screws of the rear unit as a guide then slide the
front and rear units together.
For illustration, a standard body, keypad lock with a bolt rear unit is used.
8
Connect the pin extender to the rear unit.
1
3
2
5
4
6
