PosiTouch DALI - Lighting Controller
User Manual
7.0 - 23 November 2020
Page 3 of 6
+617 3899 1267
Specifications
Physical
U n i t s
Dimensions
75 x 11.5 x 10
mm
Protrusion into wall
28.5
mm
Weight
28
g
Inputs
U n i t s
Voltage (as per IEC62386)
9
–
22.5
V
Current
10
mA
Communications
DALI (IEC62386)
Installation
Prior to installation of the PosiTouch, it should be configured using the PosiTouch
Configuration Tool. This configures the DALI commands associated with each
button.
Installation merely requires the connection of the 2 DALI wires. The PosiTouch
draws power from the DALI bus, so there is nothing further to connect. Refer to
Appendix B. DALI Networking Basics for further information regarding DALI wiring.
Operation
The PosiTouch is operated simply by touching the buttons marked on the wall
plate. When a button is active its corresponding LED will turn on, and the
associated action will trigger accordingly.
A c t i o n
D e s c r i p t i o n
Short Press
A short press action occurs when a button is pressed and released in under 0.3s.
Long Press
A long press action occurs when a button is pressed for longer than 0.3s. When some DALI
commands are assigned to a long press they are repeated until the button is released.
Release
A release action occurs when the button is released following a long press.
Table 1 Button Actions
Default Configuration
The PosiTouch comes configured by default for basic on/off and dimming control, with the configuration of
fade rate and fade time disabled.
B u t t o n
A d d r e s s
D e f a u l t A c t i o n
Short Press
Long Press
Release
1
Broadcast
Go to 100%
Go to 100%
Stop Dim
2
Broadcast
Go to 75%
Go to 75%
Disabled
3
Broadcast
Go to 50%
Go to 50%
Disabled
4
Broadcast
Go to 0%
Go to 0%
Stop Dim
5
Broadcast
Go to 25%
Go to 25%
Disabled
6
Broadcast
Go to 10%
Go to 10%
Disabled
Table 2 Default button actions.
DALI Connection
MicroUSB for use with
Configuration Tool
Figure 1 Rear view of the PosiTouch
