PosiTouch DALI - Lighting Controller
User Manual
7.0 - 23 November 2020
Page 5 of 6
+617 3899 1267
DALI Addressing
The configuration tool allows you to set an address that the commands are set to for each button. By
default each button is set to Broadcast, which means all units on the network will respond.
To use any of the other addresses you will need to commission the units to have the addresses & groups
programmed.
Dimming Options
Within the DALI standard there are 3 possible methods to dim a light fitting.
Stop Dim
Any dimming command can be halted through the use of this command. By using it in combination with
the Go to Level command (which uses the DALI Fade Time), a reliable fade can be achieved.
B u t t o n A c t i o n
T o D i m U p
T o D i m D o w n
Long Press
Go to Level
Go to Level
Level
100%
0%
Release
Stop Dim
Stop Dim
Dim up/Down
These commands will dim the level for a period of 200ms at the rate specified in DALI Fade Rate. They
cannot dim to off, nor can they dim from off. When these commands are assigned to a long press, the
PosiTouch will repeat them every 200ms while the button is pressed.
B u t t o n A c t i o n
T o D i m U p
T o D i m D o w n
Long Press
Dim Up
Dim Down
Step Up/Down
These commands will cause the output to change by a single step. When these commands are assigned to
a long Press, the PosiTouch will repeat them every 40ms. This dimming rate is not adjustable.
B u t t o n A c t i o n
T o D i m U p
T o D i m D o w n
Long Press
Step Up
Step Down
