PosiTouch DALI - Lighting Controller
User Manual
7.0 - 23 November 2020
Page 4 of 6
+617 3899 1267
Multi-Master
The PosiTouch can operate in what is referred to as Multi-Master, meaning there can be more than one
controller on the DALI network (so long as they also operate in Multi-Master).
Appendix A. Using the PosiTouch Configuration Tool
The Interface
1
Connect button
Detects and reads settings from a connected PosiTouch.
2
Save Button
Saves the settings to the connected PosiTouch
3
Status Window
Displays messages during operation
4
Fades
Used to configure the PosiTouch to program the DALI Fade Rate & Time on
start-up. If there are multiple PosiTouch units on the DALI network, these
should only be set on 1. In order for these settings to take effect, energise the
DALI network with or after applying power to the fittings being controlled.
5
Button Actions
Here the action to perform for the 3 button states (short press, long press &
release) can be configured.
6
Selected Button
Shows the button that is currently being configured. You can also click on the
button to select it.
7
About button
Configuring the PosiTouch
1.
Connect the PosiTouch to the computer using a micro-USB cable. No other connections are
required; the PosiTouch will be powered via the USB.
2.
Open the PosiTouch Configuration Tool. It should detect the connected PosiTouch. If it fails to,
check the USB cables is connected at both ends and press the connect button.
3.
Change the action for each of the buttons to the desired setup
4.
Press the save button.
1
2
3
4
5
6
7
