Torniquete
Tx1500
7.3
Configuration of control board – Switch Ds1
The switch (or dipswitch) DS1 allows programming the following actions:
-passage direction
-Maximum time for turns
-NO inputs (relay or pushbutton contact normally open and without input voltage),
enabling passage in face of these signals; or NC inputs (relay or pushbutton contact
usually closed and with input voltage), enabling passage in the absence of these
signals.
-enabling of a signal for a sound alarm if the access control remains at mid turn for more
than 5 seconds.
To program DS1, put each pin in the desired position, according to the table below.
01
02
03
04
05
06
07
08
Cleared in both directions
-
-
-
OFF
OFF
-
-
-
Blocked from left to right
-
-
-
ON
OFF
-
-
-
Blocked form right to left
-
-
-
OFF
ON
-
-
-
Blocked in both directions
-
-
-
ON
ON
-
-
-
NO inputs
-
ON
-
-
-
-
-
-
NC inputs
-
OFF
-
-
-
-
-
-
Enables sound signal
ON
-
-
-
-
-
-
-
Disables sound signal
OFF
-
-
-
-
-
-
-
Enables sound signal in mid-turn
-
-
-
-
-
ON
-
-
Disables sound signal in mid-turn
-
-
-
-
-
OFF
-
-
Wait until first turn
-
-
-
-
-
-
ON
ON
Wait for 5 seconds
-
-
-
-
-
-
OFF
ON
Wait for 10 seconds
-
-
-
-
-
-
ON
OFF
Wait for 15 seconds
-
-
-
-
-
-
OFF
OFF
Habilitation per border*
-
-
OFF
-
-
-
-
-
Habilitation per level**
-
-
ON
-
-
-
-
-
*
“
Habilitation per border
”
means that Tx1500 will be enabled by a pulse at the entry border
(NC inputs) or exit border (NO inputs).
**
“
Habilitation per level
”
means that Tx1500 will remain free as long as there is an input
signal.
7.4.
Examples of configurations
1 -
To receive a relay pulse (NO contact), clear the turning and wait to turn for 10 seconds
:
1
2
3
4
5
6
7
8
Configuration
-
ON
OFF
ON
ON
-
ON
OFF
2 - T
o leave the clockwise direction always cleared and, when the HAB2 (anti-clockwise)
clearance signal is received, clear passage for undetermined period:
1
2
3
4
5
6
7
8
Configuration
-
ON
OFF
OFF
ON
-
ON
ON
3 -
To clear the turning while the relay has the contact closed and, as soon as the relay contact
is open, remove clearance:
1
2
3
4
5
6
7
8
Configuration
-
ON
ON
ON
ON
-
ON
ON
30
