27
Torniquete
Tx1500
Passage direction
PROG1 (pin 13)
PROG2 (pin 14)
Free in both directions
Open
Open
Controlled from left to right
GND
Open
Controlled right to left
Open
GND
Controlled on both sides
GND
GND
INFORMATION:
-
ide pictogram 1 and 2 refer to the devices located on top of the
S
equipment.
-The cables of the optical sensors (CN11) and the electromagnets
(CN10) are provided alongside Tx1500.
-The cable of the box sensor (CN9) is provided alongside the
collecting box kit (optional).
INFORMATION:
PIC1 and PIC2 refer to the pictograms located on
each side of the equipment.
PIC1 (pin 15) PIC2 (pin 16) Pictogram 1 Pictogram 2
Open
Open
GND
GND
Open
GND
Open
GND
Red arrow
Red arrow
Red arrow
Red arrow
Green arrow
Green arrow
Green arrow
Green arrow
NO or NC Contact
Particularly about the CN11 connector, pins 13 and 14: Turnstile Tx1500 can be
con
fi
gured as follows to determine direction passage:
Pins 15 and 16, which control the side pictograms, must be con
fi
gured thusly:
The following sections concern important aspects of
the
control board con
fi
guration
and connections of
.
Tx1500
7.
1 Inputs
The input signals or passage clearance (HAB1 and HAB2) can be originated by a relay
contact, pushbutton contact, tension from 5 to 24 V
/ c, from 110 to 220 V
/ c. To
ac d
ac d
enable passage t