Welcome
Important information about upgrading to firmware version 20.2.x
Digi 5400-RM Cellular Remote Manager User Guide
13
6. Enable the syslog server.
If the syslog server is not enabled and set to syslog.accns.com, the device will be able to
connect to aView and receive configuration updates, but unless the aView configuration
updates set the syslog server, the device will not be able to send any metrics or logs to aView.
a. Click
System
>
Log
>
Server list
>
Server
.
b. Click
Enable
.
c. Verify that
Server
is set to
syslog.accns.com
.
d. (Optional) Select the event types to be sent to aView.
7. Click
Apply
to save the configuration and apply the change.
The
Apply
button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.
Default SureLink configuration
With firmware version 20.2.
x
, Active Recovery has been renamed to SureLink. After upgrading from a
firmware version prior to 20.2.
x
to firmware version 20.2.
x
or greater, your existing Active Recovery
configuration will remain in place. The only change will be that the feature is renamed from Active
Recovery to SureLink.
However, if you erase the configuration of a device that was upgraded from a firmware version prior
to 20.2.
x
, it will use the default SureLink settings. The default SureLink settings are:
Interface
Status
Action
Default wireless WANs (Modem)
IPv4
Enabled
Restart interface
IPv6
Disabled
Default WANs
IPv4
Enabled
Restart interface
IPv6
Disabled