PACER OPERATION:
1.
Depress D to select the PACER mode.
The display will be as shown with the last 2 digits
at the lower row blinking.
2.
At this status depress B will sequence
the PACER frequency as follows: 10, 20, 30, 40,
60, 80, 120, 160, 240, and 320.
3.
Depress A to start PACER. A beeping
sound of 320 beeps/minute will sound. The total
time elapsed will be shown on the top row, the
beep counter at the centre and PACER frequency
at the lower row.
4.
The beep counter has a range of 9999.
Depress A to stop PACER.
Remarks:
Pacer will be reset if the stopwatch is
switched to another mode.
5.
Depress D to select CLOCK mode. The
alarm hour, alarm minutes, month, date, day,
year, hour, minute and seconds are displayed as
shown.
6.
Time setting can be done by means of
depressing B to select digits and A to advance
digits.
Remarks:
Alarm is automatically armed if alarm
hour or minute has been set. Alarm can also be
armed or disarmed by depressing C at normal
time mode. When alarm is armed ‘AL’ is flashing.
When the alarm time is reached and the alarm is
armed, an output of 3 short beeps/second will
sound for 15 seconds.
If the alarm time is reached when the stopwatch
is in other modes, the alarm will only sound 3
short beeps.
CARE OF YOUR STOPWATCH:
*WATER RESISTANCE
- The stopwatch is designed to withstand
accidental contact with water such as splashes
or raindrops, but it is not designed for use in
water. Do not operate the buttons when the
stopwatch is wet.
*TEMPERATURE
- Do not leave your stopwatch under direct
sunlight or in very high temperatures for a long
time, the display may become black. Do not
leave your stopwatch in very low temperature
as this may cause a slight time loss or gain and
the change of digits becomes slow. In both
cases the above conditions will be corrected
when the stopwatch returns to normal
temperature.
*SHOCKS
- Be careful not to drop your stopwatch or hit it
against hard surfaces as it may cause a
mechanical damage.
*STATIC ELECTRICITY
- The integrated circuit in your stopwatch can
be affected by static electricity. If the static
electricity is very strong, a permanent damage
can occur. Be careful of the screen of the TV
set and the wearing of clothing made of
synthetic material in dry weather; in such cases
very strong electricity can be generated.
*MAGNETISM
- Not affected
*CHEMICALS
- Do not expose your stopwatch to
solvents such as gasoline and alcohol,
spray of cosmetics, cleaners, paints etc
as they may cause damage to the
stopwatch.
*BATTERY CHANGE
When the display becomes dim or faded
out, battery replacement is necessary.
1. Turn the battery cover off from close to
open position by using the rope holder.
2. Push the Battery Lock in the direction
shown to release the old battery.
3. Install a fresh lithium battery CR2032
into the battery holder; please make sure
the Battery Lock is in the position shown.
4. Re - install the battery cover; turn the
dot from open to close position.
THE WARRANTY DOES NOT COVER
THE BATTERY.
