DIEBOLD NIXDORF BA9x BCR series, User Manual, Page: 62 / 99

54 BA9x BCR User Manual
Configuring with Commands
The BA9x BCR can also be configured by sending command via the serial interface.
Command Format
Command
Header
Command ID
note1
Command
Terminator
<ESC> (1Bh)
None 1 to 2 characters (ASCII)
<CR> (0Dh)
[ (5Bh) 3 characters (ASCII)
] (5Dh) 4 characters (ASCII)
note1: It is possible to send multiple command IDs between a single header and terminator, except for a
single command (1-character) IDs.
Precautions
When sending multiple commands in a sequence, the subsequent command is not
received while the previous command is still being executed. Check the RTS signal
for busy state before sending the next commands.
Settings configured by commands are not retained in the non-volatile memory and
will be lost when the scan engine is powered down. To retain the setting in non-vol-
atile memory save them using the command “Z2”.
Command packet maximum buffer size is 1000 characters, sending more than the
maximum may result in commands not executed correctly.